2 replies to this topic

[ELVINA]

Hello

I'm trying to simulate lng heat exchanger in UniSim design. I have not enough data for dynamic simulation so I tried to calculate it in steady state. I have temperatures for all streams (there are one hot stream and two cold ones). But I don't know UA. Is it possible to take data from steady state to dynamic mode using only geometric sizes and stream temperatures?

Thank you

[Bobby Strain]

UniSim will calculate UA values from your steady state simulation. You can use the values in dynamic mode.

 

Bobby

[ELVINA]

Got it. Thank you very much

Edited by ELVINA, 15 September 2018 - 03:53 AM.